bsp_feature_cgc_t Struct Reference

#include <bsp_feature.h>

Data Fields
uint32_t	high_speed_freq_hz
	Frequency above which high speed mode must be used.
uint32_t	middle_speed_max_freq_hz
	Max frequency for middle speed, 0 indicates not available.
uint32_t	low_speed_max_freq_hz
	Max frequency for low speed, 0 indicates not available.
uint32_t	low_voltage_max_freq_hz
	Max frequency for low voltage, 0 indicates not available.
uint32_t	low_speed_pclk_div_min
	Minimum divisor for peripheral clocks when using oscillator stop detect.
uint32_t	low_voltage_pclk_div_min
	Minimum divisor for peripheral clocks when using oscillator stop detect.
uint32_t	hoco_freq_hz
	HOCO frequency.
uint32_t	main_osc_freq_hz
	Main oscillator frequency.
uint8_t	modrv_mask
	Mask for MODRV in MOMCR.
uint8_t	modrv_shift
	Offset of lowest bit of MODRV in MOMCR.
uint8_t	sodrv_mask
	Mask for SODRV in SOMCR.
uint8_t	sodrv_shift
	Offset of lowest bit of SODRV in SOMCR.
uint8_t	pll_div_max
	Maximum PLL divisor.
uint8_t	pll_mul_min
	Minimum PLL multiplier.
uint8_t	pll_mul_max
	Maximum PLL multiplier.
uint8_t	mainclock_drive
	Main clock drive capacity.
uint32_t	iclk_div: 4
	ICLK divisor.
uint32_t	pllccr_type: 2
	0: No PLL, 1: PLLCCR, 2: PLLCCR2
uint32_t	pll_src_configurable: 1
	Whether or not PLL clock source is configurable.
uint32_t	has_subosc_speed: 1
	Whether or not MCU has subosc speed mode.
uint32_t	has_lcd_clock: 1
	Whether or not MCU has LCD clock.
uint32_t	has_sdram_clock: 1
	Whether or not MCU has SDRAM clock.
uint32_t	has_usb_clock_div: 1
	Whether or not MCU has USB clock divisor.
uint32_t	has_pclka: 1
	Whether or not MCU has PCLKA clock.
uint32_t	has_pclkb: 1
	Whether or not MCU has PCLKB clock.
uint32_t	has_pclkc: 1
	Whether or not MCU has PCLKC clock.
uint32_t	has_pclkd: 1
	Whether or not MCU has PCLKD clock.
uint32_t	has_fclk: 1
	Whether or not MCU has FCLK clock.
uint32_t	has_bclk: 1
	Whether or not MCU has BCLK clock.
uint32_t	has_sdadc_clock: 1
	Whether or not MCU has SDADC clock.
uint32_t	set_bck_with_pckb: 1
	Whether or not BCK bits should be set with PCKB bits.

Detailed Description

CGC MCU specific features.

---

The documentation for this struct was generated from the following file:

• bsp_feature.h