/***********************************************************************************************************************
* File Name    : readme.txt
* Description  : Contains general information about Example Project and detailed instructions.
***********************************************************************************************************************/

1. Project Overview:
    The example project demonstrates the typical use of the CMT module APIs.
    Timer configuration: periodic compare-match interrupt every 500 ms.
    No user interaction is required after startup.

2. Software Requirements:
    Renesas Flexible Software Package (FSP): Version 4.1.0
    e2 studio: Version 2026-04.1
    GCC ARM Embedded Toolchain: Version 13.3.1.arm-13-24
    SEGGER J-Link RTT Viewer: Version 8.60

3. Hardware Requirements:
    RZ supported boards: RZ/N2L-RSK.
    1 x RZ board.
    1 x USB Type-C cable.
    1 x USB Type-A to micro USB cable.

4. Hardware Configurations:
    (1) Boot Mode:
        16-bit bus boot mode (NOR flash).
    (2) Set for DIP switches and jumpers as follow:
    Hardware Connection:

        1. *External flash memory must be blank to start this sample program (RAM execution).
        NOR flash memory on this board is blank, so set the operating mode switch for 16-bit bus boot mode (NOR flash).
        SW4.1 : ON
        SW4.2 : OFF
        SW4.3 : ON

       2. *To use LED, set SW to:
        SW 4.6 : OFF
        SW 4.7 : ON
       
        SW 8.1 : OFF
        SW 8.2 : ON
        SW 8.3 : OFF
       
        SW11.1 : ON
        SW11.2 : OFF
        SW11.3 : OFF

Note:
1. Segger RTT block address may be needed to download and observe EP operation using a hex file with RTT-Viewer.
   RTT Block address for hex file committed in repository are as follows:
   a. e2studio: 0x30100000

2. If an EP is modified, compiled, and downloaded please find the block address (for the variable in RAM called _SEGGER_RTT) 
   in .map file generated in the build configuration folder (Debug/Release).