flash_partitions.h

Go to the documentation of this file.

 
#ifndef FLASH_PARTITIONS_H_
#define FLASH_PARTITIONS_H_
 
#ifndef PARTITION_TABLE_BEGIN
#define PARTITION_TABLE_BEGIN
#endif
 
#ifndef PARTITION_TABLE_ENTRY
/*
 * This to create partition entry in partition table.
 */
#define PARTITION_TABLE_ENTRY(start, size, id)
#endif
 
#ifndef PARTITION
/*
 * This macro can be used to define partition without specifying size. Size of partition created
 * with this macro will be computed using next partition starting address.
 * When this macro is used partition entries must be put in partition table in ascending starting
 * offset order.
 * Last entry in partition table can't be created with this macro.
 */
#define PARTITION(start, id, flags)
#endif
 
#ifndef PARTITION2
/*
 * This macro creates partition entry in similar way as PARTITION_TABLE_ENTRY but adds flags field.
 * In this case id_START and id_SIZE macros must be defined.
 */
#define PARTITION2(id, flags)
#endif
 
#ifndef PARTITION_TABLE_END
#define PARTITION_TABLE_END
#endif
 
#define PARTITION_TABLE_ADDR NVMS_PARTITION_TABLE_START
 
PARTITION_TABLE_BEGIN
#include <partition_table.h>
PARTITION_TABLE_END
 
#endif /* FLASH_PARTITIONS_H_ */