partition_table.h

Go to the documentation of this file.

 
#define NVMS_PRODUCT_HEADER_PART_START  (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00001000)
#define NVMS_PRODUCT_HEADER_PART_SIZE   (0x00002000)
 
/* The size of the firmware image should be contained within the memory range that can be accessed
 * by M33, which is determined by the default flash region size (512KB) in relation to the base
 * address. If the FW image exceeds this size, the M33 will be unable to access the extra code. */
#define NVMS_FW_EXEC_PART_START         (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00003000)
#define NVMS_FW_EXEC_PART_SIZE          (0x0007D000)
 
/* +----------------512KB---------------------+ */
 
#define NVMS_GENERIC_PART_START         (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00080000)
#define NVMS_GENERIC_PART_SIZE          (0x00080000)
#define NVMS_PLATFORM_PARAMS_PART_START (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00100000)
#define NVMS_PLATFORM_PARAMS_PART_SIZE  (0x000FF000)
/* Recommended location, 4KB before the end of the 1st flash section. */
#define NVMS_PARAM_PART_START           (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x001FF000)
#define NVMS_PARAM_PART_SIZE            (0x00001000)
 
/* +------------------2MB---------------------+ */
/* The size of the update firmware image should be contained within the memory range that can be
 * accessed by M33, which is determined by the default flash region size (512KB) in relation to the
 * base address. If the FW image exceeds this size, the M33 will be unable to access the extra code. */
#define NVMS_FW_UPDATE_PART_START       (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00200000)
#define NVMS_FW_UPDATE_PART_SIZE        (0x0007D000)
#define NVMS_LOG_PART_START             (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x0027D000)
#define NVMS_LOG_PART_SIZE              (0x00183000)
/* To maintain consistency across various partition tables and facilitate reading without requiring
 * the rebuilding of flashing tools, it is strongly recommended to position the NVMS_PARTITION_TABLE
 * section at the end of the Embedded Flash. */
#define NVMS_PARTITION_TABLE_START      (EFLASH_MEM1_VIRTUAL_BASE_ADDR + 0x0003F800)
#define NVMS_PARTITION_TABLE_SIZE       (0x00000800)
 
PARTITION2( NVMS_PRODUCT_HEADER_PART  , 0 )
PARTITION2( NVMS_FW_EXEC_PART         , 0 )
PARTITION2( NVMS_GENERIC_PART         , PARTITION_FLAG_VES )
PARTITION2( NVMS_PLATFORM_PARAMS_PART , PARTITION_FLAG_READ_ONLY )
PARTITION2( NVMS_PARAM_PART           , 0 )
PARTITION2( NVMS_FW_UPDATE_PART       , 0 )
PARTITION2( NVMS_LOG_PART             , 0 )
PARTITION2( NVMS_PARTITION_TABLE      , PARTITION_FLAG_READ_ONLY )