partition_table.h

Go to the documentation of this file.

 
#define NVMS_PRODUCT_HEADER_PART_START  (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00001000)
#define NVMS_PRODUCT_HEADER_PART_SIZE   (0x00002000)
#define NVMS_FIRMWARE_PART_START        (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00003000)
#define NVMS_FIRMWARE_PART_SIZE         (0x0006D000)
#define NVMS_PARAM_PART_START           (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00070000)
#define NVMS_PARAM_PART_SIZE            (0x00010000)
#define NVMS_BIN_PART_START             (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x00080000)
#define NVMS_BIN_PART_SIZE              (0x00060000)
#define NVMS_LOG_PART_START             (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x000E0000)
#define NVMS_LOG_PART_SIZE              (0x00010000)
#define NVMS_GENERIC_PART_START         (QSPI_MEM1_VIRTUAL_BASE_ADDR + 0x000F0000)
#define NVMS_GENERIC_PART_SIZE          (0x010000)
/* To maintain consistency across various partition tables and facilitate reading without requiring
 * the rebuilding of flashing tools, it is strongly recommended to position the NVMS_PARTITION_TABLE
 * section at the end of the Embedded Flash. */
#define NVMS_PARTITION_TABLE_START      (EFLASH_MEM1_VIRTUAL_BASE_ADDR + 0x0003F800)
#define NVMS_PARTITION_TABLE_SIZE       (0x00000800)
 
PARTITION2( NVMS_PRODUCT_HEADER_PART  , 0 )
PARTITION2( NVMS_FIRMWARE_PART        , 0 )
PARTITION2( NVMS_PARAM_PART           , 0 )
PARTITION2( NVMS_BIN_PART             , 0 )
PARTITION2( NVMS_LOG_PART             , 0 )
PARTITION2( NVMS_GENERIC_PART         , PARTITION_FLAG_VES )
PARTITION2( NVMS_PARTITION_TABLE      , PARTITION_FLAG_READ_ONLY )