partition_table.h

Go to the documentation of this file.

 
/*
 * When partition_table is not overridden by adding a custom partition_table.h file to a project
 * then this file is used to select partition table by macro definition.
 *
 * To use layout other than SDK one, add include path into the project settings that will point
 * to a folder with the custom partition_table file.
 */
 
 
#  if defined(USE_PARTITION_TABLE_EFLASH_WITH_SUOTA)
#   include <EFLASH/suota/partition_table.h>
#  elif defined(USE_PARTITION_TABLE_1MB_WITH_SUOTA)
#   include <1M/suota/partition_table.h>
#  elif defined(USE_PARTITION_TABLE_4MB_WITH_SUOTA)
#   include <4M/suota/partition_table.h>
#  elif defined(USE_PARTITION_TABLE_1MB)
#   include <1M/partition_table.h>
#  else
#   if (dg_configCODE_LOCATION == NON_VOLATILE_IS_EMBEDDED_FLASH) || \
       (dg_configCODE_LOCATION == NON_VOLATILE_IS_NONE)
#    include <EFLASH/partition_table.h>
#   elif (dg_configCODE_LOCATION == NON_VOLATILE_IS_QSPI_FLASH)
#    include <4M/partition_table.h>
#   endif
#  endif
 
 
/*
 * Define a maximal size of the image which could be written to QSPI - based on the partition sizes.
 */
#if defined(NVMS_FW_EXEC_PART_SIZE) && defined(NVMS_FW_UPDATE_PART_SIZE)
#if NVMS_FW_EXEC_PART_SIZE < NVMS_FW_UPDATE_PART_SIZE
#define IMAGE_PARTITION_SIZE    NVMS_FW_EXEC_PART_SIZE
#else
#define IMAGE_PARTITION_SIZE    NVMS_FW_UPDATE_PART_SIZE
#endif /* NVMS_FW_EXEC_PART_SIZE < NVMS_FW_UPDATE_PART_SIZE */
#elif defined(NVMS_FIRMWARE_PART_SIZE)
#define IMAGE_PARTITION_SIZE    NVMS_FIRMWARE_PART_SIZE
#else
#error "At least one partition where application could be placed should be defined!"
#endif /* defined(NVMS_FW_EXEC_PART_SIZE) && defined(NVMS_FW_UPDATE_PART_SIZE) */